Thursday, November 18, 2010

Tooling Plate & Spacer Blocks Update

Almost forgot-here's some pics I should have shown sooner of the blocks I had made to raise my tooling plate above the surface of my Taig's table (the last thing I'd been rambling on about before the "sins and temptations of the flesh" thing that's kept me so busy after school and work lately).  The tooling plate has been mocked up for initial measurements and data although not much else has been done with it as of yet.  My schedule should open up a bit more in early December so there should also be more time for my projects with working forty or fifty hour weeks and a month break from classes...

All five of the blocks have since been finished and ground together: one 0.484x1x4" for the center of the plate and four 0.484x2x4" to be spaced equally along the length of the table.  More holes will still have to be drilled and counterbored or tapped in order to use all five blocks, but I believe the additional support under the tooling plate with them will prove to deflect under loads much less then using only three of this size (as I have mocked up under the tooling plate at this time).  I would guess that the installation of these blocks will also help to strengthen the Taig's aluminum table a small amount-a few other factors come into play here and since I'm no engineer I can't really say for certain, but it seems like adding a few braces and a backing plate as thick as or thicker than the thinnest portion of an extruded flat plate would in most cases add a bit of structural support to the original extruded flat plate alone.

These pics were posted in my last post also, but there are also some pics of a stepper motor threaded mount cover I had built for the Taig with an engraved reference line for the micrometer dials after the first four...